How To Set Up Numus Masternode Coin

  • Masternode system requirement for running demon (Ubuntu):

    sudo apt-get install libboost-all-dev software-properties-common libminiupnpc-dev
    sudo add-apt-repository ppa:bitcoin/bitcoin
    sudo apt-get update
    sudo apt-get install libdb4.8++-dev

    numus.conf (on masternode)
    port=28121
    masternode=1
    masternodeaddr=8.8.8.8:28121
    masternodeprivkey=putyourkeyhere
    daemon=1
    rpcuser=numus
    rpcpassword=putyourpasswordhere
    rpcallowip=127.0.0.1

NUMUS COIN SPECS

    • Current node setup draft:
    • Hot/cold setup
    • Note – if your vps has less then 2gb of ram you need to configure swap before the compiling:
    • sudo fallocate -l 2G /swapfile
    • sudo chmod 600 /swapfile
    • sudo mkswap /swapfile
    • sudo swapon /swapfile
    • git clone http://
    • echo ‘/swapfile none swap sw 0 0’ | sudo tee -a /etc/fstab
    • On the VPS:
    • sudo apt-get update
    • sudo apt-get install dh-autoreconf build-essential libtool autotools-dev autoconf automake libssl-dev libboost-all-dev libevent-dev pkg-config
    • bsdmainutils git libminiupnpc-dev libprotobuf-dev protobuf-compiler libqrencode-dev software-properties-common libgmp3-dev git nano
    • sudo add-apt-repository ppa:bitcoin/bitcoin
    • sudo apt-get update
    • sudo apt-get install libdb4.8-dev libdb4.8++-dev
    • git clone https://github.com/numuscrypto/numuscore
    • cd numuscore/src
    • make -f makefile.unix
    • On your cold wallet (usually Windows):
    • in your qt wallet open HELP->Debug windows -> Console
    • put command: masternode genkey
    • plus put command: masternode outputs
    • save output (first one is your privkey, second one is txhash and txid (number at the end))
    • On the VPS:
    • ./numusd
    • (previous command will show message that you need to fill up numus.conf – its ok)
    • nano ~/.numus/numus.conf
    • paste this (change ip – ip of vps, and yourkey is privkey):
    • daemon=1
    • rpcuser=user
    • rpcpassword=password
    • rpcallowip=127.0.0.1
    • port=28121
    • masternode=1
    • server=1
    • listen=1
    • masternodeaddr=ip:28121
    • masternodeprivkey=yourkey
    • ./numusd –daemon
    • On your cold wallet (usually Windows):
    • go to Masternodes -> My Master Nodes tab
    • click create
    • allias: any name
    • address: nodeip:28121
    • privkey: mnprivatekey
    • txhash: masternodeoutputshash
    • output index: yourtxindex (0 or 1)
    • Click update
    • Click start
    Done

 

Leave a Reply

Your email address will not be published. Required fields are marked *