How to Setup Medic Coin Masternode VPS

We recommend digitalocean VPS. Medic Coin Masternodes were successfully tested on digitalocean.com

1. Login to Your Server with: ssh [email protected]<server ip>
2. Now get the Medic Coin daemon by typing wget https://mediccoin.com/MedicCoind
3. Enter command : sudo apt-get update
4. Now for Install Dependency:
sudo apt-get -y update && sudo apt-get -y install build-essential libssl-dev libdb++-dev libboost-all-dev libcrypto++-dev libqrencode-dev libminiupnpc-dev libgmp-dev libgmp3-dev autoconf autogen automake libtool
5. sudo chmod +x MedicCoind
6. Now you need to start daemon. type ./MedicCoind (there is a dot infront of /)
As you enter this command you get error like you have to make config file.
For that follow next step.
7. Now enter command : sudo nano ~/.MedicCoin/MedicCoin.conf
8. Now you got blank screen in that you have to put config file.
Paste the below lines into this MedicCoin.conf file:

rpcuser=Yourusername
rpcpassword=Yourpassword
rpcallowip=127.0.0.1
daemon=1
server=1
listen=1
port=2118
rpcport=2117

9. After you pasted config file write ctrl+x and press Y and then press enter.
10. Now for start daemon again put command which you put in step 7. : ./MedicCoind
11. Now you got server starting. Then Press enter.
12. Now to get information of balance and blocks etc. Put this command : ./MedicCoind getinfo

Start MN on Daemon

Masternode Guide:

1. ./MedicCoind –daemon to start Medic coin server (if not done so)

2. ./MedicCoind getinfo to get information about the server.

3. ./MedicCoind getnewaddress MN1 you should get an address Msdfae333tc.etc.etc….

4. Send EXACTLY 199,999 medic coin to the above address. You can not send 200,000 coins or 199,998 and hope it would work. Only 199,999 coins. You can check to see if you have received the coin by typing ./MedicCoind getinfo

5. ./MedicCoind masternode genkey write this down to put in the MedicCoin.conf file

6. sudo nano ~/.MedicCoin/MedicCoin.conf to edit the MedicCoin.conf file
rpcuser=Yourusername
rpcpassword=Yourpassword
rpcallowip=127.0.0.1
daemon=1
server=1
listen=1
port=2118
rpcport=2117
masternode=1
masternodeprivkey=<paste your genkey>   (ex. masternodeprivkey=aEdh202kjhkbKHJs5…).
press ctrl+x. now press Y so you go to return in main terminal.

7. ./MedicCoind encryptwallet (your password here)    to encrypt the wallet and do not forget this password or you will can not access to your coins

9.  ./MedicCoind stop  to stop the Medic Coin server

10. ./MedicCoind –daemon to start medic coin

11. Now for start masternode with this command. : ./MedicCoind masternode start   yourpasswordhere
Masternode will start after 16 confirmations

Leave a Reply

Your email address will not be published. Required fields are marked *